Setting up Verosa with PAX S300
Prepare the Device to Receive the File Connect an ethernet cable to the red LAN port on your device Unplug and plug your S300 back into power While it is booting up, press the Function Key when the screen says “Self-Test” Once the device loads, tap MENU on the bottom right Press 4 for Remote Installation Press 1 for New Installation Press 1 for TCP The screen will…
Adjusting key volume Pax A-Series device
By default, the key volume on Pax A-series is set to “on” and is loud enough to hear in a busy store setting. How do I turn off or turn down the key volume on my PAX A-Series Device? To change the key beep volume or turn beeps off, follow these instructions: First, access settings…
Connecting PAX A-series device to internet
Some PAX devices may not be internet enabled when they first arrive. if your terminal does not have an active internet connection, follow these steps. First, access the Settings: (password is either pax9876, 9876, or pax9876@@) Setting Ethernet Setting WiFi Connection
Resolving “Error in Batch” on Pax Terminal
After attempting to settle an open batch, the error message that prints out says “Error in Batch”. This error means that there is a corrupted transaction in the open batch that is preventing the authorizations from settlement. Batches will not close, but new transactions will be allowed to authorize. Fixing “Error in Batch” on a…
How to Complete a Manual Sale on PAX A80/A920
A manual sale is one where the customer’s card is not physically present at the time of purchase or there is something preventing the card from being Swiped or Chipped. How to Complete a Manual Sale on PAX A80/A920 Tap Sale Enter the dollar amount of the sale Tap Confirm (or press the green key…
Settle Batch PAX A80/A920
After a transaction is authorized, for it to be funded to the merchant’s linked bank account, it must be settled. This is completed by closing or settling the batch. Settling Batch PAX A80/A920 Tap FUNC Tap Batch Tap Batch Close If prompted to settle with untipped transactions, confirm your choice and either tap OK settle…
Settings Password for PAX Terminal
For Pax S-series terminals the password is the current date. Example: February 11, 2020 would be 02112020 Example: March 9, 2019 would be 03092019 If that date does not work try “tomorrow’s” date instead For Pax A-series terminals refer to the chart below: